Zapi AC-2 Manuel d'utilisateur télécharger pdf (Page 41)

ADEZP0DC - AC-2 FLASH INVERTER - User Manual Page - 41/72

6) ADJUSTMENT #04

This parameter determines the motor temperature level at which the “Motor

temperature” alarm is signalled. The range is from 70 °C to 160 °C with 10 °C

steps. This parameter must be adjusted only if the “Set temperature” (menu

“Set option”) parameter is programmed “Analog”.

7) ADJUSTMENT #03

This parameter isn’t used.

8) ADJUSTMENT #02

It adjusts the lower level of the battery discharge table.

9) ADJUSTMENT #01

It adjusts the upper level of the battery discharge table.

10) LOAD HM FROM MDI

For an explanation of this point see the MDI instrument handbook.

11) PWM ON MAIN CONT

- OFF: the inverter applies the battery voltage to the loads on the main

contactor coil.

- ON: the PWM reduces the voltage at the loads on the main contactor

coil down to 62% of the battery voltage.

12) PWM ON AUX OUT.

- OFF: the inverter applies the battery voltage to the loads on the auxiliary

output.

- ON: the PWM reduces the voltage at the loads on the auxiliary output

down to 62% of the battery voltage.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 71 72

Pas de commentaire

Zapi AC-2 Manuel d'utilisateur Page 41